Bandry

Production

How to record piano and keys at home (digital, acoustic and synths)

By the Bandry Team  ยท  Nov 5, 2026  ยท  7 min read

You recorded the piano part through your laptop mic because the keyboard sounded great in the room. Played back, it's thin, boxy and full of fan noise. Or you plugged in over USB, hit record, and got a track with no sound in it at all. Learning how to record piano is mostly knowing which of three very different jobs you're doing.

A digital piano, a synth and an acoustic upright all get called keys, and keyboard players switch between them constantly. But one sends a clean electrical signal, one sends note data, and one is a huge wooden box full of strings that the room shapes as much as the mic does. Each needs its own approach.

How to Record a Digital Piano or Keyboard

Most stage pianos, workstations and synths have line outputs on the back. That's the cleanest way in.

  • Two cables, two inputs. Run the L/Mono and R outputs into two line inputs on your audio interface with quarter-inch cables. Set those inputs to line level and leave phantom power off.
  • Record in stereo. Pianos and pads lose a lot of their width and movement when summed to mono. Record both sides as one stereo track.
  • Don't trust USB blindly. On many digital pianos the USB port carries only MIDI, not audio. Check the manual before you build a session around it.
  • Set levels with headroom. Play the loudest chords in the song while you set the input, and keep the keyboard's own volume high enough that you're not boosting noise at the interface.

Record MIDI and Audio Together

MIDI isn't sound. It's a record of which keys you pressed, how hard, and when. That makes it hugely flexible: you can fix one wrong note, tighten timing, or swap the sound for any software instrument after the take.

The safest habit is to record both at once. Connect the keyboard's audio outputs to the interface and its MIDI over USB or a MIDI cable, then arm an audio track and a MIDI track together. You keep the real sound you performed with, plus a MIDI copy you can edit. Check that the sustain pedal shows up in the MIDI track, because a part recorded without its pedal data plays back choppy and dry.

How to Mic an Upright Piano

An acoustic piano sounds different at every spot around it, and a home room adds its own problems. Start by pulling the piano a little away from the wall so the back isn't firing boomy reflections into the room.

  • Over the top. Open the lid and place a pair of mics about 6 to 12 inches above the strings, pointed down, one toward the low end and one toward the high end.
  • From the back. Put a mic six inches or more from the soundboard on the back of the piano. It tends to sound warmer and picks up less pedal and key noise.
  • Compare, then commit. Record a short test in each spot and play them back on speakers. Different pianos and rooms favor different positions.

If you use two mics, check them in mono to make sure the low end doesn't thin out, the same phase check our guide to recording bass walks through for a DI and amp blend.

Make Keys Sit in a Band Mix

A solo piano wants to fill the whole stereo field and every frequency. In a band, that same sound fights the guitars, the bass and the vocal. Arrangement fixes most of this before the mix.

  • Watch the left hand. A big left-hand part doubles the bass and muddies the low end. In a full band, play lighter down there or leave it out.
  • Pick a range. If the guitar is strumming in the middle of the neck, voice the keys higher or lower so each part has its own space.
  • Fewer notes, more feel. A simple, steady pad or a few well-placed chords often sound bigger in a mix than a busy part.

Get a Clean Take

Keys are unforgiving on a recording. Every rushed chord and uneven note is right there, with no amp or room to hide it.

  • Play to the click. Track keys after drums and bass, or at least to a click, so the part locks to the band.
  • Check the touch. A keyboard with a light action can make every note hit too hard. Adjust the velocity curve in its settings until soft playing actually sounds soft.
  • Kill the noise. Turn off the keyboard's built-in reverb and effects for the recording, and add them in the mix where you can change them. On an acoustic, listen for squeaky pedals and creaky benches before you roll.

When a Studio Piano Is Worth It

If the song is built on piano, a well-maintained grand in a good room is hard to beat at home. Booking a few hours just for the piano part is a common move: track everything else at home, then take the session to a studio with a tuned piano and an engineer who knows how to mic it. Ask whether the piano is tuned before your session, and book with enough notice for them to do it.

Using Bandry for this

Looking for a player? Drop a Seeking post on the Bandry Bulletin for Keys or a Session musician, and when someone who fits taps ๐Ÿ”—, their contact lands in your Linkups inbox. Need a room with a real piano? The Resources tab runs a live Apple Maps search for studios near you. Start with recording studios near you.

Frequently asked questions

How do you record a digital piano into a computer?

Run the piano's line outputs, usually labeled L/Mono and R, into two line inputs on an audio interface with quarter-inch cables, set the inputs to line level and leave phantom power off. Record both channels as a stereo track. If your piano only has a headphone jack, that works too at a sensible volume. Check the manual before relying on USB, since on many pianos it carries only MIDI.

Is it better to record keyboard as MIDI or audio?

Record both if you can. Audio captures the sound your keyboard actually makes. MIDI captures only the notes and how hard you played them, which you can send to any software instrument later and edit note by note. Arm a MIDI track and an audio track and record them at the same time, so you keep the real sound and the option to change it.

How do you mic an upright piano at home?

Pull the piano a little away from the wall and open the lid. A common start is a pair of mics about 6 to 12 inches above the strings, pointed down. Another option is to mic it from the back, a mic six inches or more from the soundboard, which sounds warmer and picks up less pedal noise. Try both and keep what sounds better in your room.

Should piano be recorded in stereo?

Usually, yes. Piano covers a huge range of notes, and in stereo the low notes and high notes spread across the speakers the way they do from the bench. Pads and other keyboard sounds also lose much of their width and movement when collapsed to mono. In a busy band mix you can still narrow the piano later, but you cannot add real stereo afterward.

Why does my MIDI piano sound wrong on playback?

Often the sustain pedal was not recorded. If the pedal is plugged into the keyboard but the keyboard does not send pedal data, or the pedal is plugged into a different device, the notes play back dry and choppy. Check that the pedal shows up as controller data in the MIDI track. Velocity also matters: a keyboard with a light touch can make every note sound too loud.

Ready to try it?

Bandry is live on the App Store. Download it and start posting.

Download

Follow Bandry